Default password for WashTec router

Here you find how to configure and reset WashTec Router.

Most WashTec routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from WashTec

the login information may change for each model you would find login data in detail for WashTec in the section below.

# Login data for WashTec

Accessing the user interface is important once you need to change the router settings.For the WashTec , you have to do the following steps for access:

IP address:
00001 , 00000
(Show password)
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# WashTec available router models

Model Ip Username Password
WashTec SoftCare Evo Type SE10 00001 , 00000 (Show password)

# Which specific WashTec model I have?

For WashTec router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by WashTec start with Was on some model. Subsequently, a combination of letters and digits follows.

# My WashTec model is not listed above

If your WashTec model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of WashTec routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a WashTec model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.