Default password for No Geek Needed router

Here you find how to configure and reset No Geek Needed Router.

Most No Geek Needed routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from No Geek Needed

the login information may change for each model you would find login data in detail for No Geek Needed in the section below.

# Login data for No Geek Needed

Accessing the user interface is important once you need to change the router settings.For the No Geek Needed , you have to do the following steps for access:

IP address:
(Show password)
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# No Geek Needed available router models

Model Ip Username Password
No Geek Needed NGNHWI-N3 (Show password)

# Which specific No Geek Needed model I have?

For No Geek Needed router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by No Geek Needed start with No on some model. Subsequently, a combination of letters and digits follows.

# My No Geek Needed model is not listed above

If your No Geek Needed model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of No Geek Needed routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a No Geek Needed model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.