Default Password for Netgear WG302v2 Router

To get access to Netgear WG302v2 router, you need the login IP address of your router, the username, and password.

You can find these data in Netgear WG302v2 router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Netgear WG302v2 Router

The Netgear WG302v2 has a web interface for configuration. You can use any web browser to log in to the Netgear WG302v2 router.

Put the Internal IP Address of your Netgear WG302v2 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear WG302v2 login infomation.

Default login data for Netgear WG302v2

You need to know the username and password to log in to your Netgear WG302v2 router. We listed below.

ModelIpUsername & Password
Netgear WG302v2192.168.0.228Username:admin/ Password:password

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear WG302v2 Login Problems

If you not be able to get a login to your router, here are some possible solutions you can try.

The Password of Netgear WG302v2 Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Netgear WG302v2 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Netgear WG302v2 Router To Default Settings?

If you still can not get logged in, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear WG302v2 Default Wifi Name (SSID)

By default, some Netgear WG302v2 routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear WG302v2

MAC filtering allows you to restrict access to your Netgear WG302v2 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear WG302v2 router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.228 on the address.
  2. Enter the username and password for Netgear WG302v2 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

five + 2 =

  1. Joyce Alice

    Thank goodness!

    Reply
  2. Yehudi Nora

    While I searched all over the world for the default password of this damn router, I find it here.

    Reply
  3. Annabelle Henley

    It really helped me!

    Reply