Default Password for Netgear VMDG49 Router

To get access to Netgear VMDG49 router, you need the login IP address of your router, the username, and password.

You can find these info in Netgear VMDG49 router manual. But if you lost it, then you can use the quick guide below.

Login to the Netgear VMDG49 Router

The Netgear VMDG49 has a web interface for configuration. You can use any web browser to log in to the Netgear VMDG49 router.

Put the Login IP Address of your Netgear VMDG49 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear VMDG49 login username & password.

Default login data for Netgear VMDG49

You need to know the username and password to log in to your Netgear VMDG49 router. We listed below.

ModelIpUsername & Password
Netgear VMDG49192.168.0.1Username:(none)/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear VMDG49 Login Problems

If you not be able to get a login to your router, here are a few possible solutions you can try.

The Password of Netgear VMDG49 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netgear VMDG49 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Netgear VMDG49 Router To Default Settings?

If you still can’t get logged in, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 8 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear VMDG49 Default Wifi Name (SSID)

By default, some Netgear VMDG49 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear VMDG49

MAC filtering allows you to restrict access to your Netgear VMDG49 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear VMDG49 router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Netgear VMDG49 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

five × 3 =

  1. Brian Symons

    Thank you!

    Reply
  2. Hunter Joshua

    Yes, It works…

    Reply
  3. Chester Maria

    While I searched all over the world for the default password of this damn router, I find it here.

    Reply