Default Password for Netcomm 3G10WVT Router

To get access to Netcomm 3G10WVT router, you need the login IP address of your router, the username, and password.

You can find these info in Netcomm 3G10WVT router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Netcomm 3G10WVT Router

The Netcomm 3G10WVT has a web interface for configuration. You can use any web browser you like to log in to the Netcomm 3G10WVT router.

Put the Login IP Address of your Netcomm 3G10WVT in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netcomm 3G10WVT login infomation.

Default login data for Netcomm 3G10WVT

You need to know the username and password to log in to your Netcomm 3G10WVT router. We listed below.

ModelIpUsername & Password
Netcomm 3G10WVT192.168.1.1[Show username & password]

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netcomm 3G10WVT Login Problems

If you not be able to get a login to your router, here are a few possible solutions you can try.

The Password of Netcomm 3G10WVT Doesn’t Work

You should try the other same brands’ passwords. We have a large list of Brands’ Passwords that you can have a try to check. Perhaps your router’s default password is different than what we have listed here. Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of router.

Forgot Password to Netcomm 3G10WVT Router

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Netcomm 3G10WVT Router To Default Settings

If you still can not get logged in, then you have to reset your router to its default settings.

Change Netcomm 3G10WVT Default Wifi Name (SSID)

By default, some Netcomm 3G10WVT routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netcomm 3G10WVT

MAC filtering allows you to restrict access to your Netcomm 3G10WVT router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netcomm 3G10WVT router. Be sure to update this information when adding or removing devices.

How to configure:

  1. Open the web browser and type the IP address.
  2. Enter the username and password for Netcomm 3G10WVT router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

3 × 2 =

  1. Delia Palmer

    It really helped me!

  2. Marshall IV.

    It really helped me!