Default Password for Net-Lynx WR514R Router

To get access to Net-Lynx WR514R router, you need the login IP address of your router, the username, and password.

You can find these data in Net-Lynx WR514R router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Net-Lynx WR514R Router

The Net-Lynx WR514R has a web interface for configuration. You can use any web browser to log in to the Net-Lynx WR514R router.

Put the Internal IP Address of your Net-Lynx WR514R in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Net-Lynx WR514R login data.

Default login data for Net-Lynx WR514R

You need to know the username and password to log in to your Net-Lynx WR514R router. We listed below.

ModelIpUsername & Password
Net-Lynx WR514R192.168.1.1Username:admin/ Password:1234

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Net-Lynx WR514R Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Net-Lynx WR514R Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Net-Lynx WR514R router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Net-Lynx WR514R Router To Default Settings?

If you can not get logged in, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Net-Lynx WR514R Default Wifi Name (SSID)

By default, some Net-Lynx WR514R routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Net-Lynx WR514R

MAC filtering allows you to restrict access to your Net-Lynx WR514R router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Net-Lynx WR514R router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.1 on the address.
  2. Enter the username and password for Net-Lynx WR514R router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

12 − 5 =

  1. Horace Occam

    While I searched all over the world for the default password of this damn router, I find it here.

    Reply
  2. Boyd Jane

    Yes, It works…

    Reply
  3. Samuel Haggai

    While I searched all over the world for the default password of this damn router, I find it here.

    Reply