Default password for Nanoteq router
Here you find how to configure and reset Nanoteq Router.
Most Nanoteq routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Nanoteq
the login information may change for each model you would find login data in detail for Nanoteq in the section below.
# Login data for Nanoteq
Accessing the user interface is important once you need to change the router settings.For the Nanoteq , you have to do the following steps for access:
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.
# Nanoteq available router models
|Nanoteq NetSeq firewall||admin||(Show password)|
# Which specific Nanoteq model I have?
For Nanoteq router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.
# How do I know the model name?
The names of router models by Nanoteq start with Nan on some model. Subsequently, a combination of letters and digits follows.
# My Nanoteq model is not listed above
If your Nanoteq model is not listed above, please contact us here. we will try to add it shortly.
#Where do I find the model name of my router?
The model name of Nanoteq routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case
If you own a Nanoteq model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.