Default password for Innocom router

Here you find how to configure and reset Innocom Router.

Most Innocom routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Innocom

the login information may change for each model you would find login data in detail for Innocom in the section below.

# Login data for Innocom

Accessing the user interface is important once you need to change the router settings.For the Innocom , you have to do the following steps for access:

In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Innocom available router models

Model Ip Username Password
Innocom IT-WL543 (Show password)
Innocom XMedia IT-WL542 (Show password)

# Which specific Innocom model I have?

For Innocom router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Innocom start with Inn on some model. Subsequently, a combination of letters and digits follows.

# My Innocom model is not listed above

If your Innocom model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Innocom routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Innocom model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.