Default password for iBaby Labs router

Here you find how to configure and reset iBaby Labs Router.

Most iBaby Labs routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from iBaby Labs

the login information may change for each model you would find login data in detail for iBaby Labs in the section below.

# Login data for iBaby Labs

Accessing the user interface is important once you need to change the router settings.For the iBaby Labs , you have to do the following steps for access:

IP address:
(Show password)
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# iBaby Labs available router models

Model Ip Username Password
iBaby Labs M3 admin (Show password)

# Which specific iBaby Labs model I have?

For iBaby Labs router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by iBaby Labs start with iBa on some model. Subsequently, a combination of letters and digits follows.

# My iBaby Labs model is not listed above

If your iBaby Labs model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of iBaby Labs routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a iBaby Labs model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.