Default password for Helmholz Systeme router

Here you find how to configure and reset Helmholz Systeme Router.

Most Helmholz Systeme routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Helmholz Systeme

the login information may change for each model you would find login data in detail for Helmholz Systeme in the section below.

# Login data for Helmholz Systeme

Accessing the user interface is important once you need to change the router settings.For the Helmholz Systeme , you have to do the following steps for access:

IP address:
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Helmholz Systeme available router models

Model Ip Username Password
Helmholz Systeme NETLink PRO HW 1-1a-1 and FW 1. 54 and higher NETLink PRO PoE admin

# Which specific Helmholz Systeme model I have?

For Helmholz Systeme router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Helmholz Systeme start with Hel on some model. Subsequently, a combination of letters and digits follows.

# My Helmholz Systeme model is not listed above

If your Helmholz Systeme model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Helmholz Systeme routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Helmholz Systeme model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.