Default Password for Genexis DRG700 Router

To get access to Genexis DRG700 router, you need the login IP address of your router, the username, and password.

You can find these information in Genexis DRG700 router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Genexis DRG700 Router

The Genexis DRG700 has a web interface for configuration. You can use any web browser you like to log in to the Genexis DRG700 router.

Put the Internal IP Address of your Genexis DRG700 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Genexis DRG700 login username & password.

Default login data for Genexis DRG700

You need to know the username and password to log in to your Genexis DRG700 router. We listed below.

ModelIpUsername & Password
Genexis DRG700192.168.1.1[Show username & password]

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Genexis DRG700 Login Problems

If you can’t get a login to your router, here are some possible solutions you can try.

The Password of Genexis DRG700 Doesn’t Work

You should try the other same brands’ passwords. We have a large list of Brands’ Passwords that you can have a try to check. Perhaps your router’s default password is different than what we have listed here. Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of router.

Forgot Password to Genexis DRG700 Router

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Genexis DRG700 Router To Default Settings

If you still can not get logged in, then you have to reset your router to its factory settings.

Change Genexis DRG700 Default Wifi Name (SSID)

By default, some Genexis DRG700 routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Genexis DRG700

MAC filtering allows you to restrict access to your Genexis DRG700 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Genexis DRG700 router. Be sure to update this information when adding or removing devices.

How to configure:

  1. Open the web browser and type the IP address.
  2. Enter the username and password for Genexis DRG700 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

  1. Juliet Noel


  2. Maggie Steinbeck

    While I searched all over the world for the default password of this damn router, I find it here.