Default Password for Encore ENHWI-G2 Router

To get access to Encore ENHWI-G2 router, you need the login IP address of your router, the username, and password.

You can find these data in Encore ENHWI-G2 router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Encore ENHWI-G2 Router

The Encore ENHWI-G2 has a web interface for configuration. You can use any web browser you like to log in to the Encore ENHWI-G2 router.

Put the Internal IP Address of your Encore ENHWI-G2 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Encore ENHWI-G2 login infomation.

Default login data for Encore ENHWI-G2

You need to know the username and password to log in to your Encore ENHWI-G2 router. We listed below.

ModelIpUsername & Password
Encore ENHWI-G2192.168.1.1[Show username & password]

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Encore ENHWI-G2 Login Problems

If you can not get a login to your router, here are some possible solutions you can try.

The Password of Encore ENHWI-G2 Doesn’t Work

You should try the other same brands’ passwords. We have a large list of Brands’ Passwords that you can have a try to check. Perhaps your router’s default password is different than what we have listed here. Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of router.

Forgot Password to Encore ENHWI-G2 Router

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Encore ENHWI-G2 Router To Default Settings

If you still can not get logged in, then you have to reset your router to its default settings.

Change Encore ENHWI-G2 Default Wifi Name (SSID)

By default, some Encore ENHWI-G2 routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Encore ENHWI-G2

MAC filtering allows you to restrict access to your Encore ENHWI-G2 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Encore ENHWI-G2 router. Be sure to update this information when adding or removing devices.

How to configure:

  1. Open the web browser and type the IP address.
  2. Enter the username and password for Encore ENHWI-G2 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

  1. Alvin Lincoln

    Yes, It works…

  2. Belle Pigou

    While I searched all over the world for the default password of this damn router, I find it here.