Default password for EnCAD router
Here you find how to configure and reset EnCAD Router.
Most EnCAD routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from EnCAD
the login information may change for each model you would find login data in detail for EnCAD in the section below.
# Login data for EnCAD
Accessing the user interface is important once you need to change the router settings.For the EnCAD , you have to do the following steps for access:
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.
# EnCAD available router models
|EnCAD XPO||none||(Show password)|
# Which specific EnCAD model I have?
For EnCAD router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.
# How do I know the model name?
The names of router models by EnCAD start with EnC on some model. Subsequently, a combination of letters and digits follows.
# My EnCAD model is not listed above
If your EnCAD model is not listed above, please contact us here. we will try to add it shortly.
#Where do I find the model name of my router?
The model name of EnCAD routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case
If you own a EnCAD model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.