Default password for Edge-corE router

Here you find how to configure and reset Edge-corE Router.

Most Edge-corE routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Edge-corE

the login information may change for each model you would find login data in detail for Edge-corE in the section below.

# Login data for Edge-corE

Accessing the user interface is important once you need to change the router settings.For the Edge-corE , you have to do the following steps for access:

IP address:
(Show password)
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Edge-corE available router models

Model Ip Username Password
Edge-corE ECW7210 (Show password)
Edge-corE ECW5110 (Show password)
Edge-corE ECG9210-04 admin (Show password)
Edge-corE ECG9210 admin (Show password)

# Which specific Edge-corE model I have?

For Edge-corE router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Edge-corE start with Edg on some model. Subsequently, a combination of letters and digits follows.

# My Edge-corE model is not listed above

If your Edge-corE model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Edge-corE routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Edge-corE model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.