Default Password for Dlink DPG-2000W Router

To get access to Dlink DPG-2000W router, you need the login IP address of your router, the username, and password.

You can find these information in Dlink DPG-2000W router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

The Dlink DPG-2000W has a web interface for configuration. You can use any web browser to log in to the Dlink DPG-2000W router.

Put the IP Address(without “http://” or “https://”) of your Dlink DPG-2000W in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DPG-2000W login username & password.

You need to know the username and password to log in to your Dlink DPG-2000W router. We listed below.

ModelIpUsername & Password
Dlink DPG-2000W192.168.98.170Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

If you can’t get a login to your router, here are some possible solutions you can try.

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

If you still can not login the setup page of router, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

By default, some Dlink DPG-2000W routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DPG-2000W

MAC filtering allows you to restrict access to your Dlink DPG-2000W router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DPG-2000W router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.98.170 on the address.
  2. Enter the username and password for Dlink DPG-2000W router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

ten + four =

  1. Simon Edie

    Thank you!

    Reply
  2. Tabitha Brewster

    Thank goodness!

    Reply
  3. Elvira Lincoln

    thanks

    Reply