Default Password for Dlink DIR-300NRU Router

To get access to Dlink DIR-300NRU router, you need the login IP address of your router, the username, and password.

You can find these info in Dlink DIR-300NRU router manual. But if you lost it, then you can use the quick guide below.

The Dlink DIR-300NRU has a web interface for configuration. You can use any web browser to log in to the Dlink DIR-300NRU router.

Put the Login IP Address of your Dlink DIR-300NRU in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DIR-300NRU login username & password.

You need to know the username and password to log in to your Dlink DIR-300NRU router. We listed below.

ModelIpUsername & Password
Dlink DIR-300NRU192.168.0.1Username:admin/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

If you can not get a login to your router, here are a few possible solutions you can try.

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

If you still can not login the setup page of router, then you have to reset your router to its factory settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

By default, some Dlink DIR-300NRU routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DIR-300NRU

MAC filtering allows you to restrict access to your Dlink DIR-300NRU router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DIR-300NRU router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Dlink DIR-300NRU router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

6 − one =

  1. Megan Alice

    Thank you!

    Reply
  2. Charlotte IV.

    thanks

    Reply
  3. Emmanuel Bird

    It really helped me!

    Reply