Default Password for Cisco DPC2320 Router

To get access to Cisco DPC2320 router, you need the login IP address of your router, the username, and password.

You can find these information in Cisco DPC2320 router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Cisco DPC2320 Router

The Cisco DPC2320 has a web interface for configuration. You can use any web browser you like to log in to the Cisco DPC2320 router.

Put the Internal IP Address of your Cisco DPC2320 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Cisco DPC2320 login data.

Default login data for Cisco DPC2320

You need to know the username and password to log in to your Cisco DPC2320 router. We listed below.

ModelIpUsername & Password
Cisco DPC2320192.168.1.1[Show username & password]

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Cisco DPC2320 Login Problems

If you can't get a login to your router, here are a few possible solutions you can try.

The Password of Cisco DPC2320 Doesn't Work

You should try the other same brands' passwords. We have a large list of Brands' Passwords that you can have a try to check. Perhaps your router's default password is different than what we have listed here. Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

Forgot Password to Cisco DPC2320 Router

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router's login data are, or maybe they can reset it for you.

How to Reset the Cisco DPC2320 Router To Default Settings

If you still can not get logged in, then you have to reset your router to its factory settings.

Change Cisco DPC2320 Default Wifi Name (SSID)

By default, some Cisco DPC2320 routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router's brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Cisco DPC2320

MAC filtering allows you to restrict access to your Cisco DPC2320 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Cisco DPC2320 router. Be sure to update this information when adding or removing devices.

How to configure:

  1. Open the web browser and type the IP address.
  2. Enter the username and password for Cisco DPC2320 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

  1. Cliff Symons

    3Q

    Reply
  2. Chester Betty

    Thank you!

    Reply