Default password for Beam router
Here you find how to configure and reset Beam Router.
Most Beam routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Beam
the login information may change for each model you would find login data in detail for Beam in the section below.
# Login data for Beam
Accessing the user interface is important once you need to change the router settings.For the Beam , you have to do the following steps for access:
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.
# Beam available router models
|Beam GW410||unknown||(Show password)|
# Which specific Beam model I have?
For Beam router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.
# How do I know the model name?
The names of router models by Beam start with Bea on some model. Subsequently, a combination of letters and digits follows.
# My Beam model is not listed above
If your Beam model is not listed above, please contact us here. we will try to add it shortly.
#Where do I find the model name of my router?
The model name of Beam routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case
If you own a Beam model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.