Default password for Anker router

Here you find how to configure and reset Anker Router.

Most Anker routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Anker

the login information may change for each model you would find login data in detail for Anker in the section below.

# Login data for Anker

Accessing the user interface is important once you need to change the router settings.For the Anker , you have to do the following steps for access:

IP address:
(Show password)
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Anker available router models

Model Ip Username Password
Anker Uspeed 300Mbps dual band router admin (Show password)
Anker Uspeed Dual Band Router 600Mbps admin (Show password)
Anker Uspeed 600Mbps dual band router admin (Show password)
Anker Uspeed Dual-Band USB Adapter (Show password)
Anker Uspeed Dual Band Router 300Mbps admin (Show password)

# Which specific Anker model I have?

For Anker router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Anker start with Ank on some model. Subsequently, a combination of letters and digits follows.

# My Anker model is not listed above

If your Anker model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Anker routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Anker model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.