Default Password for A-Link RoadRunner 24 Router

To get access to A-Link RoadRunner 24 router, you need the login IP address of your router, the username, and password.

You can find these data in A-Link RoadRunner 24 router manual. But if you lost it, then you can use the quick guide below.

The A-Link RoadRunner 24 has a web interface for configuration. You can use any web browser you like to log in to the A-Link RoadRunner 24 router.

Put the IP Address(without "http://" or "https://") of your A-Link RoadRunner 24 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your A-Link RoadRunner 24 login infomation.

You need to know the username and password to log in to your A-Link RoadRunner 24 router. We listed below.

ModelIpUsername & Password
A-Link RoadRunner 24192.168.1.1[Show username & password]

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

If you not be able to get a login to your router, here are some possible solutions you can try.

You should try the other same brands' passwords. We have a large list of Brands' Passwords that you can have a try to check. Perhaps your router's default password is different than what we have listed here. Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of router.

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router's username and password are, or maybe they can reset it for you.

If you still can not get logged in, then you are probably going to reset your router to its factory settings.

By default, some A-Link RoadRunner 24 routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router's brand, which makes it easier for hackers.

Configure Wireless MAC address filter for A-Link RoadRunner 24

MAC filtering allows you to restrict access to your A-Link RoadRunner 24 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your A-Link RoadRunner 24 router. Be sure to update this information when adding or removing devices.

How to configure:

  1. Open the web browser and type the IP address.
  2. Enter the username and password for A-Link RoadRunner 24 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Rate article
Add a comment

  1. Alger Ingersoll

    While I searched all over the world for the default password of this damn router, I find it here.

  2. Daisy Babbitt

    While I searched all over the world for the default password of this damn router, I find it here.