Default password for SeeedStudio router

Here you find how to configure and reset SeeedStudio Router.

Most SeeedStudio routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from SeeedStudio

the login information may change for each model you would find login data in detail for SeeedStudio in the section below.

# Login data for SeeedStudio

Accessing the user interface is important once you need to change the router settings.For the SeeedStudio , you have to do the following steps for access:

IP address:
192.168.7.2
Username:
debian
Password:
temppwd
IP address:
192.168.100.1
Username:
root
Password:
change on install
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# SeeedStudio available router models

Model Ip Username Password
SeeedStudio BeagleBone 192.168.7.2 debian temppwd
SeeedStudio LinkIt Smart 7688 192.168.100.1 root change on install

# Which specific SeeedStudio model I have?

For SeeedStudio router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by SeeedStudio start with See on some model. Subsequently, a combination of letters and digits follows.

# My SeeedStudio model is not listed above

If your SeeedStudio model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of SeeedStudio routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a SeeedStudio model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.

Top