Default password for Pass and Seymour router

Here you find how to configure and reset Pass and Seymour Router.

Most Pass and Seymour routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Pass and Seymour

the login information may change for each model you would find login data in detail for Pass and Seymour in the section below.

# Login data for Pass and Seymour

Accessing the user interface is important once you need to change the router settings.For the Pass and Seymour , you have to do the following steps for access:

IP address:
192.168.1.1
Username:
none
Password:
none
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Pass and Seymour available router models

Model Ip Username Password
Pass and Seymour CNR-7562V none none

# Which specific Pass and Seymour model I have?

For Pass and Seymour router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Pass and Seymour start with Pas on some model. Subsequently, a combination of letters and digits follows.

# My Pass and Seymour model is not listed above

If your Pass and Seymour model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Pass and Seymour routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Pass and Seymour model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.

Top