Default password for Multilaser router

Here you find how to configure and reset Multilaser Router.

Most Multilaser routers have a default login information (combinations of IP address, username and password) to access the user interface. you can see in the section below the default settings of all available router models from Multilaser

the login information may change for each model you would find login data in detail for Multilaser in the section below.

# Login data for Multilaser

Accessing the user interface is important once you need to change the router settings.For the Multilaser , you have to do the following steps for access:

IP address:
192.168.1.1
Username:
admin
Password:
admin
In order to improve our service, please give us your feedback. Don't forget you can contact us

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

# Multilaser available router models

Model Ip Username Password
Multilaser RE024 admin admin

# Which specific Multilaser model I have?

For Multilaser router, you will find in most cases the name of the model on a sticker that in the back or the bottom to the device.

# How do I know the model name?

The names of router models by Multilaser start with Mul on some model. Subsequently, a combination of letters and digits follows.

# My Multilaser model is not listed above

If your Multilaser model is not listed above, please contact us here. we will try to add it shortly.

#Where do I find the model name of my router?

The model name of Multilaser routers is usually written on a sticker on the device. In most cases, you can find this sticker on the back or bottom of the case

If you own a Multilaser model that is not listed above, please contact us here. We will try to add the missing information as soon as possible.

Top